Products > SPM Division > Semi-Automatic gauging Systems

Semi-Automatic Gauging Systems

Semi-Automatic Gauging Stations are often used with Part Specific Fixtures to measure multiple parameters..
  • Typically used in high volume precision parts between processes. e.g. OP-10 machine with gauge checking parameters for the parts being produced.
  • Gauging Stations are kept next to the machine, to eliminating part movement. Cycle times are generally ⅓rd of the machining time. This also gives ample time for the operator to load & unload parts from the gauge.
  • These systems are used to provide closed-loop feedback for auto-correction.
  • We provide on-site service and support for gauge maintenence. Customers often keep all necessary spares' stock to achieve Zero downtime.

Components include :
  • Engine Blocks
  • Cylinder Sleeves
  • Pistons
  • Connecting Rods
  • Cam and Crank Shafts
  • Small engine shim selection and assembly gauges
  • Fuel Injector Components
  • Rocker Arms
  • Heads
  • Pinion Gear Blanks
  • Race Bearings
  • Rotors
  • Bearing Spindles
  • Tie Rods
  • Spark Plugs
  • Transmission Plates
  • Turbo Charger Shafts
  • Engine Dampeners
  • Trans-axle Housings
  • Wheel Rims
  • Wheel Hubs
  • Brake Rotors
  • Gears
  • Shaft
  • Tablet Punch

Features measured include all Geometric Dimensioning and Tolerancing (GD&T) type requirements for very tight tolerance features including :
  • Inner Diameter and Outer Diameter Features
  • Dynamic Inner Diameter and Outer Diameter Averages
  • Dynamic Inner Diameter and Outer Diameter - Minimum and Maximum
  • Dynamic Run-outs
  • Parallelism
  • Flatness
  • Perpendicularity
  • Roundness
  • Positions
  • Concentricity
  • Dimension over Pin